Ceramic Printer Guide for WASP Delta Printer

Posted on: Last updated on: Written by:

Intro

WASP ceramic printer
This is WASP

Steps when starting to print

Preparation of clay

Make the clay. the consistency should be very homogenous, soft and a bit wet but not too wet. Hand mixing felt like it helped, possibly also for packing it into the tube

0.6 BAR max pressure
open the valve on the right to release pressure from the chamber. The top one is from the compressor and fills the tank.
make sure the fan is ON or the stepper will overload. This cable was replaced by me. Sorry for the sloopy electrical tape, but it seemed to be resilient.