PCB Production

Bring your electronics experiments to the next level with the Aalto Fablab PCB production capabilities. We have two milling machines (Roland SRM-20 and MDX-40) capable of milling circuit boards out of copper-covered FR1 and FR2 clads. Design your board in KiCad or any other electronics design software and use the equipment available to produce it.

Our vinyl copper is available to cut copper tape in order to produce flexible circuit boards. Use heat resistant epoxy or Kapton tape as the base surface for copper traces and go as far as adding a layer of solder mask.

A reasonably wide variety of electronics components is available at the lab. We keep our stock updated with parts from the official Fab Inventory. It is essential to have the parts mentioned there to be able to run the Fab Academy.

Contact information
  • Solomon_Embafrash
    Solomon Embafrash

    Aalto Fablab Manager

    solomon.embafrash@aalto.fi

  • Krisjanis Rijnieks

    Fablab Master

    krisjanis.rijnieks@aalto.fi

This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.